After-sales Service: | Support Customization |
---|---|
Power Source: | Electric |
Automatic Grade: | Full-Automatic |
Shipping Cost:
Estimated freight per unit. |
about shipping cost and estimated delivery time. |
---|
Payment Method: | |
---|---|
Initial Payment Full Payment |
Currency: | US$ |
---|
Return&refunds: | You can apply for a refund up to 30 days after receipt of the products. |
---|
Suppliers with verified business licenses
Wood crusher is a new type of ideal equipment for producing sawdust. It has added a side feed port and slicing device to the original foundation, which can convert larger diameter round wood, square wood, leftover materials High fiber stem raw materials such as veneer, building formwork, corn cob, bark, leaves, branches, etc. are processed into sawdust in one go, which has the advantages of low investment, low energy consumption, high productivity, and good economic benefits, It has the advantages of convenient use and maintenance, and is widely used as a raw material for biomass particles, paper making, machine made charcoal, edible fungi, creative boards, and sawn high-density boards. |
Installation and commissioning operations 1. Configure the appropriate power cord and control switch according to the power configuration of the device, connect the power supply, and check if the motor direction is correct. 2. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts. 3. When installing, it should be noted that the main engine pulley and motor pulley are pulled in a straight line using a triangular belt 4. After installation, check whether the bolts in each part are loose and whether the main engine compartment door is fastened. If there is any looseness, please tighten it 5. It is strictly prohibited to throw wood with stones and nails into the machine to prevent damage to the knives and internal parts. 6. Pay attention to checking the hammer bolts. If any looseness is found, tighten them immediately. When the hammer and bolts are severely worn, they should be replaced 7. After the inspection is completed, conduct a no-load test run, and production can proceed once the test run is normal. 8. When the particles cannot reach the desired size, switch to a different pore size sieve. 9. When replacing the cutting tool, the blade extends 2-4mm beyond the flat surface of the cutting disc, and then tighten the bolt. If the pressure bolt thread is found to be worn, it should be replaced immediately to prevent damage to the sliding disc nut. |
Suppliers with verified business licenses